Range Rover Evoque: Rear Drive Halfshafts

READ NEXT:

 Rear Halfshaft LH

Special Tool(s) 205-857 Remover, Halfshaft 205-928 Remover, Half Shaft Inboard Joint Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow

 Rear Halfshaft RH

Special Tool(s) 205-857 Remover, Halfshaft 205-928 Remover, Half Shaft Inboard Joint Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Rear Halfshaft LH (205-05 Rear Drive H

SEE MORE:

 Steering Linkage

Tie Rod End Special Tool(s) 205-754A Splitter, Ball Joints Removal NOTE: RH illustration shown, LH is similar. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation). 3. 4. CAUTIO

 Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit. Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks. Before raising the vehicle, the wheel diagonally opposite the one to be removed must be chocked. Always chock the wheel

© 2011-2025 Copyright www.rrevoque.org