Range Rover Evoque: Standard Workshop Practices
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Description and Operation / General Information / Standard Workshop Practices
- Vehicle in Workshop
- Bolt and Nut Identification
- Pipes and Hoses
- Electrical Precautions
- Supplementary Restraint System (SRS) Precautions
- Front Airbag Deployment - Driver and Passenger
READ NEXT:
Vehicle in Workshop
When working on a vehicle in the workshop always make sure that:
Where practicable, the parking brake is applied and the wheels are
securely chocked to prevent the vehicle moving
forwards or back
Bolt and Nut Identification
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter
can be identified by either of the symbols ISO
M or M embossed or indented on top of the bolt head.
In addition to marks i
Pipes and Hoses
When removing or installing flexible hydraulic pipes and hoses, make sure
that the following procedures are observed to
make sure component serviceability:
Prior to removal, clean area around hose
SEE MORE:
Central Junction Box (CJB)
Removal
CAUTIONS:
If a new component is to be installed, the Land Rover approved diagnostic
equipment must be connected prior to
removal, the data must then be downloaded from it and the keys (remote control
handsets) set into default mode. Failure
to follow this instruction will result in permane
Battery Junction Box (BJB) TD4 2.2L
Diesel
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Central Junc
© 2011-2026 Copyright www.rrevoque.org - 0.0041
