Range Rover Evoque: Transmission Control Module (TCM) TD4 2.2L Diesel

Removal

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Air Cleaner (303-12, Removal and Installation).

3.

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

4.

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

5. CAUTION: Discard the component.

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

6.

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

7.

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

Installation

1. Torque: 25 Nm

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

2.

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

3. Torque:

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

4. CAUTION: Make sure that new components are installed.

NOTE: Do not fully tighten the clamp at this stage.

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

5. Torque: 10 Nm

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

6. Torque: 10 Nm

Range Rover Evoque. Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission

7. Refer to: Air Cleaner (303-12, Removal and Installation).

8. Reconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

9.

READ NEXT:

 Torque Converter Seal TD4 2.2L Diesel

Special Tool(s) 307-597 Installer, Torque Converter Seal 307-613 Holding Pins, Torque Converter Removal NOTE: Some variation in the illustrations may occur, but the essential information is always co

 Transmission Fluid Pan TD4 2.2L Diesel

Removal CAUTION: Extreme cleanliness must be exercised when handling this component. NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING

 Transmission TD4 2.2L Diesel - Removal

Removal Special Tool(s) 205-857 Remover, Halfshaft 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine General Equipment Transmission jack NOTE: Some variation in the

SEE MORE:

 Inner Quarter Panel and Wheelhouse

Removal NOTES: The inner quarter panel and wheelhouse is manufactured from mild steel. The aid of a second technician is required to remove, offer up and align the inner quarter panel and wheelhouse. The service panel is not fully welded. 1. In this procedure, to make sure the vehicle is correctl

 Rear Bumper Mounting

Removal NOTE: The rear bumper mounting is manufactured from mild steel. 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The rear bumper mounting is replaced in conjunction with: Rear bumper cover Rear bumper Back panel 3.

© 2011-2026 Copyright www.rrevoque.org