Range Rover Evoque: Automatic Transmission & Transaxle
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Automatic Transmission & Transaxle
- Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission
- Transmission Description - Component Location
- Transmission Description - System Operation and Component Description
- Transmission Fluid Level Check
- Transmission Fluid Drain and Refill
- Transmission Control Module (TCM) GTDi 2.0L Petrol
- Torque Converter Seal GTDi 2.0L Petrol
- Transmission GTDi 2.0L Petrol - Removal
- Transmission GTDi 2.0L Petrol - Installation
- Transmission Control Module (TCM) TD4 2.2L Diesel
- Torque Converter Seal TD4 2.2L Diesel
- Transmission Fluid Pan TD4 2.2L Diesel
- Transmission TD4 2.2L Diesel - Removal
- Transmission TD4 2.2L Diesel - Installation
- Transmission Fluid Pan GTDi 2.0L Petrol
- Transmission/Transaxle Cooling - Vehicles With: AWF21 6-Speed Automatic Transmission
- Automatic Transmission/Transaxle External Controls - Vehicles With: AWF21 6-Speed Automatic Transmission
READ NEXT:
Transmission Description - Component Location
Component Location
COMPONENT LOCATION
Auxiliary battery module
Transmission Control Switch (TCS)
Upshift (+) paddle switch
Downshift (-) paddle switch
Transmission and Gear Shift Module (GSM) b
Transmission Description - System Operation
and Component Description
Control Diagram
NOTE: A = Hardwired; D = High Speed Controller Area Network (CAN) bus; O =
Local Interconnect Network ( LIN)
Battery
Battery Junction Box (BJB)
Engine Control Module (ECM)
Centr
SEE MORE:
Fender Apron Panel Front Reinforcement
Removal
NOTES:
The fender apron panel front reinforcement is manufactured from RP220 and
mild steel.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2. The front side member and fender a
Tyre change
Valve stem seal, washer, nut,
valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and nuts
must be refitted using correct torque
figures and associated profile. Damage
to the vehicle m
© 2011-2025 Copyright www.rrevoque.org
