Range Rover Evoque: Dynamic stability control (amber)
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Warning lamps / Dynamic stability control (amber)
Dynamic stability control (amber)
Illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC system is active. If the lamp illuminates continuously while driving, there is a fault with the DSC system. The vehicle can still be driven, but the DSC system will not activate under wheel spin or slide conditions.
Seek qualified assistance as soon as possible.
READ NEXT:
Dynamic stability control off (amber)
Dynamic stability control off (amber)
Illuminates when DSC is switched
off.
Deactivating DSC also reduces the
level of Electronic Traction Control intervention
and may lead to an increase in wh
Anti-lock braking system (amber)
Anti-lock braking system (amber)
Illuminates briefly when the
ignition is switched on. If the lamp
remains on or illuminates while
driving, there is a fault with the ABS system.
Drive with care
Airbag srs (amber)
Airbag srs (amber)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp illuminates while driving,
there is a fault with the airbag syst
SEE MORE:
Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park or Reverse gear is selected
on vehicles with automatic transmission.
- Dynamic Stability Control
Wiring Harness - Description and Operation
Introduction
CAUTION: Do not use any other heat shrink sleeve other than the approved
glue lined heat shrink sleeve mentioned
in the repair procedure.
The purpose of this document is to promote quick and efficient minor repair
to harness connectors or cables using
approved methods and the wiring
© 2011-2026 Copyright www.rrevoque.org
