Range Rover Evoque: General program (special programs off)

This program is compatible with all

This program is compatible with all on and off-road conditions. If not already active, it should be selected before driving on surfaces which are similar to a hard road surface. Dry cobbles, tarmac, dry wooden planks, etc., all fall into this category.

This program should be selected once the need for a special program has passed. Once the special program has been deselected, all of the vehicle systems will return to their normal settings except HDC. HDC will remain active if it was selected manually.

READ NEXT:

 Grass-gravel-snow

This program should be used where a firm surface is covered with loose or slippery material. Note: For deep snow it is recommended that the Sand program is selected. Note: If the vehicle is una

 Mud-ruts

This program should be used for crossing terrain that is muddy, rutted, soft or uneven. HDC is automatically selected with this program.

 Sand

This program should be used for terrain which is predominantly soft dry sand or deep gravel. Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may h

SEE MORE:

 Tyre change

Valve stem seal, washer, nut, valve core and cap should be replaced at every tyre change. Valve stem seal, washer and nut must be replaced if valve retention nut is loosened. Sensor units and nuts must be refitted using correct torque figures and associated profile. Damage to the vehicle m

 Front Side Member Section

Removal NOTES: The front side member is manufactured from RP260 and DP600. The front side member section is cut from the front side member and is manufactured from RP260. This procedure is written for the LH front side member section replacement, the LH and RH front side member sections differ i

© 2011-2026 Copyright www.rrevoque.org