Range Rover Evoque: Rolling re-start

If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated.

Automatic transmission - select neutral (N) and then press the engine START/STOP button.

When the engine re-starts, select transmission position D.

Manual transmission - depress the clutch and then press the engine START/STOP button.

When the engine re-starts, select an appropriate forward gear.

READ NEXT:

 Keyless start backup

If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start t

 Stop/start (manual transmission only)

The Stop/Start system has been designed to improve fuel efficiency. The system is automatically activated when the ignition is switched on. When the engine has been stopped by the stop/start syst

 Conditions preventing automatic engine stop

The engine will not automatically stop if:<> - the external temperature is below approximately 0°C (32°F) - the external temperature is above approximately40°C (104°F) - engine has not re

SEE MORE:

 Crankshaft Position (CKP) Sensor

Special Tool(s) 303-1390A CKP Sensor Alignment Tool JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Wheel and Tire

 Instrument panel

Instrument panel 1. Speedometer. 2. Driver Information Centre (message centre). 3. Tachometer. 4. Temperature gauge Serious engine damage can occur if the vehicle is driven while the engine is overheating. If the pointer moves onto the red line the engine is overheating. Stop the vehic

© 2011-2026 Copyright www.rrevoque.org