Range Rover Evoque: Hill descent control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control
- Hill descent control (HDC) controls
- Hdc operation
- Gradient release control (GRC)
- Brake temperature
- System fault
- Automatic systems
READ NEXT:
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd o
Hdc operation
With HDC engaged, standard descent speed
will not exceed 20km/h (12.4mph).
While the green warning lamp is continuously
illuminated, HDC target speed can be modified
using the cruise control steer
Gradient release control (GRC)
With HDC activated, if the vehicle is stopped on
a slope using the foot brake, GRC will become
active (except in Terrain Response Sand
program). It operates in all gears and in neutral
position.
SEE MORE:
Replacement tyres
Do not fit cross ply tyres.
Do not fit tubed tyres.
Do not rotate tyres around the vehicle.
If the use of tyres not recommended by
Land Rover is unavoidable, ensure
that you read and fully comply with the
tyre manufacturer’s instructions.
Ideally, tyres should be replaced in sets of 4. If
Headlamps
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove the four grille fixings.
4. Remove the two retaining bolts.
5. At the rear of the headlamp unit, p
© 2011-2025 Copyright www.rrevoque.org
