Range Rover Evoque: Terrain response operation
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Terrain response / Terrain response operation
Terrain Response selection is via one of two centre console switches. Depending on vehicle specification, the control switches may include a Dynamic program setting. Use the switches to move through up to five program selections.
The currently selected program icon will be displayed in the message centre.
Note: Changing between special programs will alter various vehicle settings, e.g., engine revs while at the current accelerator pedal position may alter, or the steering feel might change.
These changes are not dramatic but will be noticable.
It is advisable to experiment with the available settings in an environment that will not affect other road users.
READ NEXT:
Dynamic
This special program is associated
with a driving style rather than a type
of terrain. Choose this program for
exploiting the vehicle's full on-road potential,
providing a more focussed and invo
General program (special programs off)
This program is compatible with all
on and off-road conditions. If not
already active, it should be selected
before driving on surfaces which are similar to
a hard road surface. Dry cobbles, tar
Grass-gravel-snow
This program should be used
where a firm surface is covered
with loose or slippery material.
Note: For deep snow it is recommended that
the Sand program is selected.
Note: If the vehicle is una
SEE MORE:
Transfer Case
Connecting Sleeve Seals GTDi 2.0L Petrol
Special Tool(s)
100-012
Slide Hammer
307-594
Installer, Seal
308-005
Remover, Axle oil seal
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
Epb automatic use
EPB will be applied automatically if the ignition
is switched off and the vehicle speed is below
3km/h (2mph).
To prevent automatic operation, when the
vehicle is stationary, press and hold the EPB
switch in the release position. Within 5
seconds, switch off the ignition and continue to
hold
© 2011-2026 Copyright www.rrevoque.org
