Range Rover Evoque manuals

Range Rover Evoque: Hill descent control

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control

READ NEXT:

 Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd o

 Hdc operation

With HDC engaged, standard descent speed will not exceed 20km/h (12.4mph). While the green warning lamp is continuously illuminated, HDC target speed can be modified using the cruise control steer

 Gradient release control (GRC)

With HDC activated, if the vehicle is stopped on a slope using the foot brake, GRC will become active (except in Terrain Response Sand program). It operates in all gears and in neutral position.

SEE MORE:

 Passenger Seat Cushion Vehicles With: Sports Seats

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General In

 Power Brake Actuation

Brake Booster - Component Location COMPONENT LOCATION - 2.2L Td4 NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar Brake booster Vacuum pipe (vehicles with stop/start system) Vacuum pump Vacuum pipe (vehicles without stop/start system) Non return val

© 2011-2025 Copyright www.rrevoque.org