Range Rover Evoque: Rear Drive Halfshafts

READ NEXT:

 Rear Halfshaft LH

Special Tool(s) 205-857 Remover, Halfshaft 205-928 Remover, Half Shaft Inboard Joint Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow

 Rear Halfshaft RH

Special Tool(s) 205-857 Remover, Halfshaft 205-928 Remover, Half Shaft Inboard Joint Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Rear Halfshaft LH (205-05 Rear Drive H

SEE MORE:

 Active On-Demand Coupling Vehicles With: M66 6-Speed Manual Transmission AWD

Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise the vehicle on a lift. 2. Remove the exhaust system. Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation). 3. CAUTION: Make sure that the driveshaft is supported with suitable retai

 Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd or reverse gears. Automatic transmission: HDC can be used in D, R and CommandShift 1, 2 or 3. Note

© 2011-2025 Copyright www.rrevoque.org