Range Rover Evoque: Instrument panel

Instrument panel
Instrument panel

1. Speedometer.
2. Driver Information Centre (message centre).
3. Tachometer.
4. Temperature gauge

occur if Serious engine damage can occur if the vehicle is driven while the engine is overheating.

If the pointer moves onto the red line the engine is overheating. Stop the vehicle as soon as safety permits and allow the engine to idle until the temperature reduces. If, after several minutes, the temperature does not reduce, switch off the engine and allow to cool. If the problem persists, seek qualified assistance immediately.

Note: If engine overheating occurs, there may be a noticeable reduction in engine power and the air conditioning may cease operation. This is a normal operating strategy, to reduce load on the engine and assist with cooling.

5. Fuel gauge.

out of Never allow the engine to run out of fuel. The resultant misfire can seriously damage the catalytic convertor.

If the amber low fuel warning lamp illuminates, the vehicle should be refuelled as soon as possible. The approximate distance that can be travelled on the remaining fuel can be viewed via the trip computer range function.

As a reminder for the location of the fuel filler, there is an arrow next to the fuel pump symbol pointing to the relevant side of the vehicle.

READ NEXT:

 Vehicle information and settings menu

Vehicle information and settings menu A number of vehicle features and display settings may be configured via the vehicle information and settings menu. To display and navigate through the vehic

 Message centre

 Warning and information messages

Do not ignore warning messages.Take appropriate action and, when necessary, seek qualified assistance before driving the vehicle. If more than one message is active, each is displayed in turn

SEE MORE:

 Component Description

LEFT STEERING COLUMN MULTIFUNCTION SWITCH Off position Side lamps position Headlamps position AUTO - Automatic headlamps position (if fitted) Front fog lamps switch Rear fog lamps switch High beam Right turn signal indicator Left turn signal indicator High beam position High beam flash

 Front Bumper Mounting

Removal NOTE: The front bumper mounting is manufactured from HSLA300 and mild steel. 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The front bumper mounting is replaced in conjunction with: Front bumper cover Front bumper

© 2011-2025 Copyright www.rrevoque.org