Range Rover Evoque: Rear Drive Halfshafts

READ NEXT:

 Rear Halfshaft LH

Special Tool(s) 205-857 Remover, Halfshaft 205-928 Remover, Half Shaft Inboard Joint Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow

 Rear Halfshaft RH

Special Tool(s) 205-857 Remover, Halfshaft 205-928 Remover, Half Shaft Inboard Joint Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Rear Halfshaft LH (205-05 Rear Drive H

SEE MORE:

 Starting a disabled vehicle using a starting aid

To start the vehicle using a starting aid or a slave battery, follow the instructions in the sequence given. 1. Connect the positive (Red) booster cable to the positive (+) battery terminal of the discharged battery. 2. Connect the negative (Black) booster cable to the vehicle earth point. 3

 Starting a disabled vehicle using booster cables

Rotating parts of the engine can cause serious injury. Take extreme care when working near rotating parts of the engine. Before attempting to start the disabled vehicle, make sure that the parking brake is applied, or suitably chock the wheels. Make sure that Park is selected or the manua

© 2011-2025 Copyright www.rrevoque.org