Range Rover Evoque: Rolling code device equipment programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Rolling code device equipment programming
Note: The assistance of a second person, may make the following steps quicker and easier.
Once the button has been pressed there are only 30 seconds in which to complete Step 3.
1. At the garage door opener receiver (motor head unit) in the garage, locate the learn or smart button/switch.
- The name of the button or switch may vary between manufacturers.
2. Press and release the learn or smart button.
3. In your vehicle, firmly press the previously programmed HomeLink opener button twice and release.
4. Press and hold briefly to complete the programming process.
HomeLink should now activate the rolling code device.
READ NEXT:
Reprogramming a single garage door opener button
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
To erase all programming
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep th
Entry gate programming
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
SEE MORE:
Manual Transmission/Transaxle and Clutch - General Information
Lubricant
Capacities
General Specification
Torque Specifications
Clutch
System Bleeding
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
All vehicles
1. Check that all the clutch line connections are tight and that there
are no signs of leaks
Rear Inner Quarter Panel
Removal
NOTES:
The rear inner quarter panel is manufactured from mild steel.
The rear inner quarter panel is unpicked from the inner quarter panel, it is not
serviced separately.
There are NVH components on this panel, they are not serviced on the new panel.
If damaged, new components will
be re
© 2011-2025 Copyright www.rrevoque.org
