Range Rover Evoque: Dual view selection
When the ignition is switched on or the audio
unit is turned on after being turned off, single
view mode will be the default view.
To select dual view, press the dual view hard
key on the fascia surround. See 111,
AUDIO/VIDEO CONTROLS.
Press again to display the dual view Options
menu. From here, a change can be made to the
viewing source or dual view can be cancelled.
If TV or a video format source were being
viewed previously, the same source will be
displayed.
READ NEXT:
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Se
If you would like to change the TV programme
while the vehicle is moving, there are two
methods available;
1. Press the dual view hardkey to display the
control menu.
Select an alternative channe
When the video programme begins play, a root
menu with information about the video
programme and its content will be displayed on
screen.
Note: Information and style may vary due to
differing vid
SEE MORE:
Removal
WARNING: This procedure involves fuel handling. Be prepared for fuel
spillage at all times and always observe fuel
handling precautions. Failure to follow these instructions may result in
personal injury.
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect
A colder ambient local temperature will reduce
pressure within the tyre. An effect is to
decrease sidewall height and to increase tyre
shoulder wear with the potential for tyre failure.
Vehicle dynamics could also be adversely
affected.
Tyre pressures can be adjusted to compensate
before the
© 2011-2025 Copyright www.rrevoque.org
