Control Diagram
NOTE: A = Hardwired; D = High Speed CAN (controller area network) bus; N =
Medium Speed CAN bus; O = LIN
(local interconnect network) bus
DW12C is shown, GTDi is similar
Battery
B
ATC MODULE
NOTE: The 'ECON' button has been renamed 'A/C' to prevent confusion with
the Stop/Start system 'Eco' switch.
The ATC module is mounted in the center console and is integral with the
cont
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
If the control module or a component is suspect
Principles of Operation
For a detailed description of the battery system and operation, refer to the
relevant Description and Operation section of
the workshop manual. REFER to: (414-01 Battery, Mounting and Cables)
Inspection and Verification
CAUTION: Diagnosis by substitution from a donor vehicle