Range Rover Evoque: Engine starting: automatic transmission
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Engine starting: automatic transmission
1. A valid Smart Key must be inside the vehicle.
2. Make sure the gear selector is in P or N.
3. Firmly depress the brake pedal.
4. Press and release the start button. The engine will crank automatically until it starts. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.
READ NEXT:
Engine starting: manual transmission
Note: Do not press the accelerator pedal when
starting the engine.
1. A valid Smart Key must be inside the
vehicle.
2. Fully depress the clutch pedal.
3. Press and release the start button. For
If the engine fails to start
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult
Switching off the engine
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
SEE MORE:
Brake System - General Information
Brake System Bleeding
CAUTION: Brake fluid will damage paint finished surfaces. If spilled,
immediately remove the fluid and clean the area
with water.
NOTES:
Bleeding of the complete brake system must be carried out using Land Rover
approved diagnostic equipment. Where
only the primary or seconda
Installing an isofix child seat
Installing an isofix child seat
To install an ISOFIX child seat:
1. Locate the ISOFIX locking mechanism.
2. Slide the child seat into the locking
mechanism.
3. If an upper tether is fitted to the child seat,
ensure it is properly secured to the upper
tether anchorages on the rear of the sea
© 2011-2025 Copyright www.rrevoque.org
