Range Rover Evoque: Hill descent control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control
- Hill descent control (HDC) controls
- Hdc operation
- Gradient release control (GRC)
- Brake temperature
- System fault
- Automatic systems
READ NEXT:
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd o
Hdc operation
With HDC engaged, standard descent speed
will not exceed 20km/h (12.4mph).
While the green warning lamp is continuously
illuminated, HDC target speed can be modified
using the cruise control steer
Gradient release control (GRC)
With HDC activated, if the vehicle is stopped on
a slope using the foot brake, GRC will become
active (except in Terrain Response Sand
program). It operates in all gears and in neutral
position.
SEE MORE:
Rear Side Member Upper Side Extension
Removal
NOTES:
The rear side member upper side extension is manufactured from mild steel.
If a new Rear side member upper side extension is being replaced in combination
with a rear side member closing
panel some MIG plug welds can be substituted for spot welds on installation
within this procedu
Digital Audio Broadcast Module (DABM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
If the control module or a component is suspect
© 2011-2026 Copyright www.rrevoque.org
