Range Rover Evoque: Switching on the ignition
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Switching on the ignition
To turn on the ignition without starting the
engine:
- Do not depress the brake/clutch pedal,
- Press the START/STOP button and hold
until the warning lamps illuminate, then
release the button.
If the brake/clutch pedal is
applied when
the start/stop button is pressed, the
engine will start.
READ NEXT:
Engine starting
Never start the engine, or
leave it
running, when the vehicle is in an
enclosed space. Exhaust gasses are
poisonous and can cause
unconsciousness and death if inhaled.
If the engine fails to
Engine starting: automatic transmission
1. A valid Smart Key must be inside the
vehicle.
2. Make sure the gear selector is in P or N.
3. Firmly depress the brake pedal.
4. Press and release the start button. The
engine will crank autom
Engine starting: manual transmission
Note: Do not press the accelerator pedal when
starting the engine.
1. A valid Smart Key must be inside the
vehicle.
2. Fully depress the clutch pedal.
3. Press and release the start button. For
SEE MORE:
Rear Stabilizer Bar
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. WARNING: Make sure that
Cleaning after off-road driving
Ensure that the areas around
air intakes
and the front grille are clean and clear of
debris. Pay particular attention to the
lower grille and radiator. Failure to do
so may cause the engine to overheat,
leading to severe engine damage.
Ensure that the vehicle underside is cleaned as
soon
© 2011-2026 Copyright www.rrevoque.org
