Range Rover Evoque: Mud-ruts

This program should be used for

This program should be used for crossing terrain that is muddy, rutted, soft or uneven. HDC is automatically selected with this program.

READ NEXT:

 Sand

This program should be used for terrain which is predominantly soft dry sand or deep gravel. Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may h

 Wading

The maximum advisable wading depth is 500mm (19.7in). If the vehicle remains stationary in water above the door sill level, severe electrical damage may occur. Do not switch off the engine when

 Driver override options

Although Dynamic Stability Control is automatically engaged when a special program is selected, it can be turned off if required. See 91, DISABLING DSC. Hill Descent Control (HDC) will be automat

SEE MORE:

 Engine Upper/Lower Support Insulator

Engine Upper Support Insulator Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. 1. Refer to: Engine Mount RH (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation)

 Fender Apron Panel Front Reinforcement

Removal NOTES: The fender apron panel front reinforcement is manufactured from RP220 and mild steel. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The front side member and fender a

© 2011-2021 Copyright www.rrevoque.org