Range Rover Evoque: Rear lamp bulbs

1. Remove the two fixings.

1. Remove the two fixings.

2. Direction indicator.

3. Reversing lamp

Turn the relevant bulb holder counter clockwise and pull to remove from the lamp unit. Grip the holder then press the bulb into the holder and turn counter clockwise to release the bulb. Pull the bulb up to remove.

READ NEXT:

 Rear fog lamp

Access to the rear fog lamp requires special tools and should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer/Authorised Repairer.

 Cleaning the exterior

Remove any heavy deposits of mud and dirt with a hose before washing the vehicle. Never aim a hose water jet directly at the engine air intake, heater air intakes, body seals or at any compone

 Using white spirit

Stubborn stains such as tar spots and grease may require the use of white spirt. After use, ensure the area is washed immediately with warm soapy water to remove all traces of the spirit.

SEE MORE:

 Control Diagram, System Operation

Control Diagram NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O = LIN (local interconnect network) bus Battery BJB (battery junction box) Front height sensor Rear height sensor Headlamp leveling control module Front right fog lamp Front left fog lamp Left side rep

 Rear Side Member Lower Side Extension

Removal NOTE: The rear side member lower side extension is manufactured from mild steel. 1. The rear side member lower side extension is replaced in conjunction with: Rear bumper cover Rear bumper Rear lamp mounting panel 2. For additional information relating to this repair procedure please

© 2011-2025 Copyright www.rrevoque.org