Range Rover Evoque: Rear seat access (coupe models)

The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch.

1. Lift the locking lever and pivot the seatback

1. Lift the locking lever and pivot the seatback forwards.

2. Press the front of the switch to power the seat forwards.

3. To return the seat, pivot the seatback until it locks into its previous position, then press and hold the rear of the switch to power the seat rearwards until it locks into position.

READ NEXT:

 Rear seats

 Folding and raising the rear seats

Folding and raising the rear seats The split fold rear seat of 5 door models can be folded completely, or partially at 60/40 split, to accommodate loads and still retain seating for passengers.

 Rear seat head restraints

Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the

SEE MORE:

 Catalyst Monitor Sensor

Special Tool(s) 310-121 Wrench, H02S Removal WARNING: Observe due care when working near a hot exhaust system. NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Disconnect the batt

 Head restraints

Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the event of a collision. Do not drive, or carry passengers with the head restraints removed from o

© 2011-2025 Copyright www.rrevoque.org