Range Rover Evoque: Standard Workshop Practices
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Description and Operation / General Information / Standard Workshop Practices
- Vehicle in Workshop
- Bolt and Nut Identification
- Pipes and Hoses
- Electrical Precautions
- Supplementary Restraint System (SRS) Precautions
- Front Airbag Deployment - Driver and Passenger
READ NEXT:
Vehicle in Workshop
When working on a vehicle in the workshop always make sure that:
Where practicable, the parking brake is applied and the wheels are
securely chocked to prevent the vehicle moving
forwards or back
Bolt and Nut Identification
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter
can be identified by either of the symbols ISO
M or M embossed or indented on top of the bolt head.
In addition to marks i
Pipes and Hoses
When removing or installing flexible hydraulic pipes and hoses, make sure
that the following procedures are observed to
make sure component serviceability:
Prior to removal, clean area around hose
SEE MORE:
Front Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Torque: 6 Nm
2. Torque: 6 Nm
3. Torque: 0.9 Nm
4. Torque: 1.3 Nm
5-door
5.
3-door
6.
All vehicles
7.
8.
9. NOTE: Do not disassemble further if the
component is removed for access only.
10.
11.
Tyre care
Do not drive the vehicle if a
tyre is
damaged, excessively worn, or
incorrectly inflated.
Avoid contaminating the tyres with
vehicle fluids as they may cause
damage to the tyre.
Avoid spinning the wheels. The forces
released can damage the structure of
the tyre and cause it to fail.
If w
© 2011-2025 Copyright www.rrevoque.org
