Range Rover Evoque: Standard Workshop Practices
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Description and Operation / General Information / Standard Workshop Practices
- Vehicle in Workshop
- Bolt and Nut Identification
- Pipes and Hoses
- Electrical Precautions
- Supplementary Restraint System (SRS) Precautions
- Front Airbag Deployment - Driver and Passenger
READ NEXT:
Vehicle in Workshop
When working on a vehicle in the workshop always make sure that:
Where practicable, the parking brake is applied and the wheels are
securely chocked to prevent the vehicle moving
forwards or back
Bolt and Nut Identification
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter
can be identified by either of the symbols ISO
M or M embossed or indented on top of the bolt head.
In addition to marks i
Pipes and Hoses
When removing or installing flexible hydraulic pipes and hoses, make sure
that the following procedures are observed to
make sure component serviceability:
Prior to removal, clean area around hose
SEE MORE:
Coolant level check
Running the engine without
coolant will
cause serious engine damage.
The coolant level in the expansion tank should
be checked at least weekly (more frequently in
high mileage or arduous operating conditions).
Always check the level when the system is
cold.
Ensure the coolant level remai
Active
On-demand Coupling Control Module
Rear Differential Control Module (RDCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOT
© 2011-2025 Copyright www.rrevoque.org
