Range Rover Evoque: Single-point/multi-point entry
When you press the unlock button, your vehicle will unlock in one of two ways: 1. Single Point Entry: Unlocks the driver's door and fuel filler flap only. A second press is required to unlock the remaining doors and the tailgate.
2. Multi-Point Entry: Unlocks all doors, fuel filler flap and the tailgate on the first press.
To change from Single to Multi-Point entry (or vise versa), press both the lock and unlock buttons simultaneously for 3 seconds. The hazard warning lamps will flash twice to confirm the change.
This feature may also be set via the settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU.
Note: If, when the vehicle is unlocked, an audible warning is emitted, this will be a ‘Mislock’ error. There may be a fault with either of the alarm sensors. Consult with your Dealer /Authorised Repairer as soon as possible.
READ NEXT:
Global opening
Press and hold the Smart Key unlock button for
3 seconds to unlock the vehicle and open all
windows.
Press any button on the Smart Key to cancel
the operation.
Keyless entry
Keyless entry allows the vehicle to be opened if
a Smart Key is within 1.0m (3ft) of the door
handle or the tailgate external switch.
The Smart Key may not be detected if it
is placed within a me
Smart key check
If the ignition is on or the engine is running and
there is no Smart Key inside the vehicle when
the last door is closed, the message Smart Key
Not Found Refer to Handbook will be displayed
in the
SEE MORE:
Intake Manifold
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specification
Central Junction Box (CJB)
Removal
CAUTIONS:
If a new component is to be installed, the Land Rover approved diagnostic
equipment must be connected prior to
removal, the data must then be downloaded from it and the keys (remote control
handsets) set into default mode. Failure
to follow this instruction will result in permane
