Range Rover Evoque: Start guidance
After touching Destination, the system will calculate the route.
There is now a choice to select 3 Routes, Change route or to Start navigation guidance.
Touch 3 Routes to display a choice of three different route options on the map.
The roads on the map are drawn in three different colours to highlight each route.
EcoRoute helps you find the most fuel efficient route available. A display of three leaves indicates the most fuel efficient route.
Select route 1, 2 or 3 by touching the respective box displayed on the right side of the map.
Touch Change Route followed by Route prefs.
to change the route settings. If a destination is already set, touch Waypoint to add a waypoint in the journey if required.
When you have made your selection, if any, touch Go.
Note: As you approach a junction, in addition to the voice guidance, an inset on the map will display an enlarged view of the junction.
READ NEXT:
Easy route
In Route options, Easy route can be turned On
or Off.
When On is selected, Easy route changes the
calculation parameters of Route 3 in order to
reduce:
- Junctions.
- Turns.
- Turns that cross
Learn route
In Route options, Learn route can be turned
On or Off.
When On is selected, if you make the same
deviation from the proposed route three times,
then the system will memorise the deviation
and off
Voice guidance
To turn voice guidance on or off but maintain
route guidance, proceed as follows:
1. Touch Nav menu on the map menu screen.
2. Touch the Route voice guidance soft key.
The soft key will be highlig
SEE MORE:
Front Side Member and Suspension Top Mount
Assembly
Removal
NOTES:
The front side member and suspension top mount assembly consists of the
front side member closing panel, fender apron panel front
reinforcement, fender apron lower panel, suspension top mount, and fender apron
panel reinforcement.
The front side member and suspension top mount is m
Suspension Top Mount
Removal
NOTES:
The suspension top mount is manufactured from mild steel and RP220.
The service panel is serviced not fully spot welded.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2.
