Range Rover Evoque: Navigation system
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Navigation system
- The navigation system
- Things you need to know
- Accessing navigation
- Vehicle position error
- Navigation controls
- Map split screen
- Screen modes
- Search area
- Setting a destination
- Start guidance
- Easy route
- Learn route
- Voice guidance
- Stop route guidance
- Quick poi selection
- Restore system defaults
- Memory points
- Memory point details
- Postcode
- Emergency
- Map
- Coordinates
- Previous
- Motorway
- Points of interest (POI)
- Dealer locations
- Entry by town
- Poi categories and sub-categories
- Search area
- List soft key
- All softkey
- Local poi search
- Rds-tmc overview
- Rds-tmc display
- Rds-tmc icons
- Level 1 tmc event icons
- Level 2 tmc event icons
- Using tmc
- Ordnance survey data
- Ownership
- Licence grant
- Licence terms
- Limitations of use
- Limitation of liability
- Navteq corporation
- Ownership
- Licence grant
- Limitations of use
- Transfer
- Disclaimer of warranty
- Limitation of liability
- Government end users
- European declaration of conformity
READ NEXT:
The navigation system
Navigation instruction is by map and turn
information displayed on the touch screen and
can be complemented by voice guidance if
required. The system uses signals from Global
Positioning System (G
Things you need to know
Operate the system only when
it is
safe to do so.
The requirements of national Road Traffic
Regulations always apply.
Observation of traffic signs and local traffic
regulations always take pri
Accessing navigation
From the Home menu touch the On road nav
soft key. Alternatively press the NAV hard key
on the facia. A caution screen will be displayed.
If the navigation screen language has not been
set, now is
SEE MORE:
Side Air Bag Module
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery
Rocker Panel
Removal
NOTES:
The rocker panel is manufactured from mild steel.
Some of the butt joints must be MIG brazed due to the location of boron
reinforcements.
1. This procedure
identifies the
method for the
replacement of
the rocker
panel in full.
The graphic
and table
identify
possible
alternative
sec
© 2011-2020 Copyright www.rrevoque.org