Range Rover Evoque: Limitations of use

The DATABASE is restricted for use in the specific system for which it was created.

Except to the extent explicitly permitted by mandatory applicable laws, you may not extract or re-utilise substantial parts of the contents of the DATABASE, not reproduce, copy, modify, adapt, translate, disassemble, decompile, or reverse engineer any portion of the DATABASE.

READ NEXT:

 Transfer

You may not transfer the DATABASE to third parties, except together with system for which it was created, provided that you do not retain any copy of the DATABASE, and provided that the transferee

 Disclaimer of warranty

NAVTEQ Corporation does not warrant or make any representations regarding, either express or implied, regarding the use or results of the use of the DATABASE in terms of its correctness, accuracy,

 Limitation of liability

The price of the DATABASE does not include any consideration for assumption of risk of consequential, indirect or unlimited direct damages which may arise in connection with your use of the DATABA

SEE MORE:

 Exterior Trim and Ornamentation

Torque Specifications Rear Quarter Panel Moulding Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. NOTE: Discard the retaining clips. Make sure that the centre part of the clip is fully removed from the outer part of the clip. It is not possible to prevent

 Rear Halfshaft LH

Special Tool(s) 205-857 Remover, Halfshaft 205-928 Remover, Half Shaft Inboard Joint Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshafts to hang unsupported at one end or joint damage will occur. Make sure the halfshaft con

© 2011-2022 Copyright www.rrevoque.org