Range Rover Evoque: Exterior Lighting - System Operation and Component Description
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Lighting / Exterior Lighting / Exterior Lighting - System Operation and Component
Description
READ NEXT:
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear heigh
Component Description
LEFT STEERING COLUMN MULTIFUNCTION SWITCH
Off position
Side lamps position
Headlamps position
AUTO - Automatic headlamps position (if fitted)
Front fog lamps switch
Rear fog lamps switch
High
Headlamp Adjustment
NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
1. Align the headlamp beam setting equipment to one headlamp.
2. Switch the headlamps on and to dipped beam.
3. NOTE: NAS vehicles ha
SEE MORE:
Transmission Control Module (TCM) TD4 2.2L
Diesel
Removal
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Air Cleaner (303-12, Removal and Installation).
3.
4.
5. CAUTION: Discard the component.
6.
7.
Installation
1. Torque: 25 Nm
2.
3. Torque:
M10 47 Nm
Fender Apron Panel Front Reinforcement
Removal
NOTES:
The fender apron panel front reinforcement is manufactured from RP220 and
mild steel.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2. The front side member and fender a
© 2011-2025 Copyright www.rrevoque.org
