Range Rover Evoque: Exterior Lighting - System Operation and Component Description
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Lighting / Exterior Lighting / Exterior Lighting - System Operation and Component
Description
READ NEXT:
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear heigh
Component Description
LEFT STEERING COLUMN MULTIFUNCTION SWITCH
Off position
Side lamps position
Headlamps position
AUTO - Automatic headlamps position (if fitted)
Front fog lamps switch
Rear fog lamps switch
High
Headlamp Adjustment
NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
1. Align the headlamp beam setting equipment to one headlamp.
2. Switch the headlamps on and to dipped beam.
3. NOTE: NAS vehicles ha
SEE MORE:
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd or reverse gears.
Automatic transmission: HDC can be used in
D, R and CommandShift 1, 2 or 3.
Note
Heater Core and Evaporator Core Housing
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
2. Refer to: Instrument Panel - TD4 2.2L Diesel (501-12 Instrument
Panel and Console, Removal a
© 2011-2025 Copyright www.rrevoque.org
