Range Rover Evoque manuals

Range Rover Evoque: Steering column lock

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Entering the vehicle / Steering column lock

Smart Key During vehicle recovery, a Smart Key must remain inside the vehicle, so that the steering column remains unlocked.

See 216, RECOVERY.

Your vehicle is fitted with an electronic steering column lock, which locks and unlocks in conjunction with the vehicle locking system. It also locks automatically, after a time delay, if the ignition is switched off and the Smart Key is removed from the vehicle.

Any malfunction of the steering column lock will be indicated by the message Steering Column Locked being displayed in the message centre. If this occurs: 1. Lock and then unlock the vehicle using the Smart Key.

2. Try again to unlock the steering column lock, by turning the steering wheel gently to the left and right.

3. If the problem persists, seek qualified assistance immediately.

READ NEXT:

 Deselecting valet mode

If Valet mode is active when you enter the vehicle, touch the Valet button to view the Valet mode screen. Enter your four digit PIN and touch the OK button. Valet mode is deactivated is displayed

 Operating the tailgate

Ensure there is minimum space of 1.0M (39 in) above the rear of vehicle before operating the tailgate. Insufficient space may result in damage to the vehicle. Do not operate the tailgate if

 Powered tailgate operation

1. Press to open the powered tailgate. 2. Press and release to close the powered tailgate. After the tailgate has opened to its set height, it can be manually raised or lowered. If the tailgate

SEE MORE:

 Transmission TD4 2.2L Diesel - Installation

Installation Special Tool(s) 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. 2. NOTE: This step is only

 Rocker Panel

Removal NOTES: The rocker panel is manufactured from mild steel. Some of the butt joints must be MIG brazed due to the location of boron reinforcements. 1. This procedure identifies the method for the replacement of the rocker panel in full. The graphic and table identify possible alternative sec

© 2011-2025 Copyright www.rrevoque.org