Range Rover Evoque: Underbody maintenance

Regularly flush the underbody with plain water, and pay particular attention to areas where mud and debris collect.

If damage or corrosion are detected, have the vehicle checked by your Dealer/Authorised Repairer as soon as possible.

READ NEXT:

 Cleaning after off-road driving

Ensure that the areas around air intakes and the front grille are clean and clear of debris. Pay particular attention to the lower grille and radiator. Failure to do so may cause the engine t

 Glass surfaces

Clean the rear window with a soft cloth to avoid damaging the heating element. Do not scrape the glass or use any abrasive cleaning fluid. Mirror glass is particularly susceptible to damage. Wash

 Cleaning the rear screen

To avoid damaging the heating elements when cleaning the inside of the rear screen, use only a soft damp cloth or chamois leather. Do not use solvents or sharp objects to clean the glass.

SEE MORE:

 Rear Lamp Mounting Panel

Removal NOTES: The rear lamp mounting panel is manufactured from mild steel. The section of the rear lamp mounting panel described within this procedure is for the access for installation of the inner back panel assembly. The upper NVH component must be replaced when a complete panel is installed

 Fuel Rail

Special Tool(s) 310-198 Installer, Teflon Seal 310-199 Re-shape Tool, Teflon Seal Removal CAUTION: Make sure that all openings are sealed. Use new blanking caps. NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. Disconnect the battery ground c

© 2011-2024 Copyright www.rrevoque.org