Range Rover Evoque manuals

Range Rover Evoque: Hill descent control

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control

READ NEXT:

 Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd o

 Hdc operation

With HDC engaged, standard descent speed will not exceed 20km/h (12.4mph). While the green warning lamp is continuously illuminated, HDC target speed can be modified using the cruise control steer

 Gradient release control (GRC)

With HDC activated, if the vehicle is stopped on a slope using the foot brake, GRC will become active (except in Terrain Response Sand program). It operates in all gears and in neutral position.

SEE MORE:

 Desiccant Bag GTDi 2.0L Petrol

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Condenser - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation). 3. Torque: 11 Nm Installation 1

 Information and Message Center

Information and Message Center - Component Location COMPONENT LOCATION Information and Message Center - Overview OVERVIEW The message center is located in the instrument cluster, in a central position between speedometer and the tachometer. The 5 inch Thin Film Transistor (TFT) display can be cont

© 2011-2025 Copyright www.rrevoque.org