Range Rover Evoque: Rear Drive Halfshafts

READ NEXT:

 Rear Halfshaft LH

Special Tool(s) 205-857 Remover, Halfshaft 205-928 Remover, Half Shaft Inboard Joint Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow

 Rear Halfshaft RH

Special Tool(s) 205-857 Remover, Halfshaft 205-928 Remover, Half Shaft Inboard Joint Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Rear Halfshaft LH (205-05 Rear Drive H

SEE MORE:

 Body Repairs - Vehicle Specific Information and Tolerance Checks

Body and Frame Front End Body Dimensions NOTES: All dimensions shown are in millimetres (mm). Dimensions shown to holes, are always taken from/to the hole centre. They are also always to the body panel surface, not to the top of bolts or components. Side Panel Dimensions 3-door version 5-d

 Steering column

Never adjust the steering column while the vehicle is in motion. 1. Move the lever fully down to unlock the column. Move the lever fully up to re-lock the column. 2. Move the steering column up, down, in or out, to the desired position. 3. Press to switch on the steering wheel heating. Te

© 2011-2025 Copyright www.rrevoque.org