Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear heigh
LEFT STEERING COLUMN MULTIFUNCTION SWITCH
Off position
Side lamps position
Headlamps position
AUTO - Automatic headlamps position (if fitted)
Front fog lamps switch
Rear fog lamps switch
High
NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
1. Align the headlamp beam setting equipment to one headlamp.
2. Switch the headlamps on and to dipped beam.
3. NOTE: NAS vehicles ha
Do not use RME (bio-diesel)
except in
the case of those proprietary diesel
fuels which contain a mix of up to 7%.
Land Rover vehicles can accept no
responsibility for damage caused by
using RME in concentrations greater
than 7%.
Use only high quality diesel fuel according to
EN590 or equi
Epb manual use
1. To apply the parking brake, with the vehicle
stationary, pull up the lever and release it.
The parking brake warning
lamp will illuminate. It is
important to confirm that the
lamp is continuously illuminated (not
flashing), as this indicates the brake has
been correctly