Range Rover Evoque: Hill descent control

READ NEXT:

 Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd o

 Hdc operation

With HDC engaged, standard descent speed will not exceed 20km/h (12.4mph). While the green warning lamp is continuously illuminated, HDC target speed can be modified using the cruise control steer

 Gradient release control (GRC)

With HDC activated, if the vehicle is stopped on a slope using the foot brake, GRC will become active (except in Terrain Response Sand program). It operates in all gears and in neutral position.

SEE MORE:

 Single locking

Single locking secures the vehicle and prevents the doors from being opened from outside. The doors may still be unlocked and opened using the interior door locks and release levers. In this state, only the perimeter (exterior) alarm is activated. When the vehicle is Single locked and the alar

 Transmission GTDi 2.0L Petrol - Removal

Special Tool(s) 205-857 Remover, Halfshaft 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine JLR-303-1591 Lifting Bracket, Engine - Rear General Equipment Transmission jack NOTE: Some variation in the illustrations may occur, but the essential information is alway

© 2011-2025 Copyright www.rrevoque.org