Lighting control
1. With the headlamps on, push the control
away from the steering wheel to select high
beam. The instrument pack warning lamp
will illuminate.
Note: Do not use high beam where
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch
This feature operates whenever the lamps
master switch is in the AUTO (5) position and
the ignition is turned off. The headlamps will
remain illuminated for up to 240 seconds.
Note: The time delay
Power Liftgate Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 4 Nm
3. Torque: 4 Nm
4.
Installation
1. To install, reverse the removal procedure.
Liftgate
Removal
CAUTION: The headliner must be lowered as a complete unit to gain access
to the
Check
WARNING: Observe due care when draining, as the fluid can be very hot.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Make sure that the automatic transmission is in the PARK position
and the handbrake is fully applied.
2. WARNING: Ma