Range Rover Evoque: Wheel changing

READ NEXT:

 Changing a road wheel

Changing a road wheel 1. Temporary spare wheel locking ring. 2. Temporary spare wheel retaining bolt. 3. Tool kit retaining bolt. 4. Jack. 5. Wheel brace. After use, the tool kit should be

 Removing the temporary spare wheel

Remove the spare wheel prior to jacking the vehicle, to avoid destabilising the vehicle when raised. Do not use power tools to loosen the spare wheel. Doing so may damage the mechanism. 1.

 Temporary spare wheel

Always adhere to the instructions given on the temporary use spare wheel warning label. Failure to comply can be dangerous. When a temporary use spare wheel is fitted, drive with caution and r

SEE MORE:

 Brake systems (red)

Brake systems (red) Illuminates briefly when the ignition is switched on. If the lamp illuminates while driving, suspect low brake fluid level or a fault with the Electronic Brake Distribution (EBD) system. Stop the vehicle as soon as safety permits. If the message CHECK BRAKE FLUID is dis

 Rear Side Member Upper Side Extension

Removal NOTES: The rear side member upper side extension is manufactured from mild steel. If a new Rear side member upper side extension is being replaced in combination with a rear side member closing panel some MIG plug welds can be substituted for spot welds on installation within this procedu

© 2011-2026 Copyright www.rrevoque.org