Range Rover Evoque: Exterior lights

READ NEXT:

 Lighting control

Lighting control 1. With the headlamps on, push the control away from the steering wheel to select high beam. The instrument pack warning lamp will illuminate. Note: Do not use high beam where

 Daytime running lamps

Daytime running lamps are LED lamps. With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch

 Headlamp courtesy delay

This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay

SEE MORE:

 Balance Shaft Assembly

Special Tool(s) JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation detail

 Fuel System - General Information

Capacities Fuel System Pressure Release GTDi 2.0L Petrol Draining 1. Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions (100-00 General Information, Description and Operation). 2. Remove the fuel pump fuse. 3. Remove the fuel filler cap. 4. Start the engine and allow it

© 2011-2025 Copyright www.rrevoque.org