Range Rover Evoque: Engine Cooling - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine Cooling - GTDi 2.0L Petrol
- Engine Cooling - Component Location, System Operation and Component Description
- Cooling System Draining, Filling and Bleeding
- Radiator
- Cooling Fan
- Cooling System Partial Draining, Filling and Bleeding
- Engine Cooling - Diagnosis and Testing
- Block Heater
READ NEXT:
Engine Cooling - Component Location, System Operation and
Component Description
Component Location
COMPONENT LOCATION
Heater core
Air Conditioning (A/C) Evaporator (ref only)
Heater inlet hose
Heater outlet hose/Oil cooler inlet hose
Turbocharger water outlet pipe
Water o
Cooling System Draining, Filling and
Bleeding
Draining
CAUTIONS:
The engine cooling system must be maintained with the correct
concentration and type of anti-freeze solution to
prevent corrosion and frost damage. Failure to follow this instructi
Radiator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure
SEE MORE:
Trailer electrical connection
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output
which must not be exceeded. An accessory
harness kit increasing output to 15 amp is
available from your Land Rover Dealer.
When a trailer electrica
Fender Apron Panel Front Reinforcement
Removal
NOTES:
The fender apron panel front reinforcement is manufactured from RP220 and
mild steel.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2. The front side member and fender a
© 2011-2025 Copyright www.rrevoque.org
