Lighting control
1. With the headlamps on, push the control
away from the steering wheel to select high
beam. The instrument pack warning lamp
will illuminate.
Note: Do not use high beam where
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch
This feature operates whenever the lamps
master switch is in the AUTO (5) position and
the ignition is turned off. The headlamps will
remain illuminated for up to 240 seconds.
Note: The time delay
Lubricant
Capacities
General Specification
Torque Specifications
Clutch
System Bleeding
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
All vehicles
1. Check that all the clutch line connections are tight and that there
are no signs of leaks
The fuel consumption figures shown below have been calculated using a
standard testing
procedure (the new EC test procedure from Directive 99/100/EC), and produced in
accordance with
The Passenger Car Fuel Consumption (Amendment) Order 1996.
Under normal use, a vehicle’s actual fuel consump