Range Rover Evoque: Decreasing cruise speed
To reduce cruising speed, press and hold
control (4). Release the switch when the
desired speed is reached, the new speed will be
set and maintained.
The set speed can be decreased in steps of
2km/h (1mph), by briefly pressing control (4).
READ NEXT:
Suspend cruise control with a single press of
control (3).
To resume cruise control at the previous set
speed, press control (2).
RES (2) should be used only
if the
driver is aware of the set
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
SEE MORE:
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and
Removal
NOTES:
This procedure covers the removal and installation of both rear seat
backrests and the LH rear seat backrest cover.
The RH rear seat backrest cover is similar. All notes and cautions must be
followed strictly to avoid any chance of NVH or
failure of the rear seat backrests.
5-door
© 2011-2022 Copyright www.rrevoque.org