Range Rover Evoque: Exterior lights

READ NEXT:

 Lighting control

Lighting control 1. With the headlamps on, push the control away from the steering wheel to select high beam. The instrument pack warning lamp will illuminate. Note: Do not use high beam where

 Daytime running lamps

Daytime running lamps are LED lamps. With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch

 Headlamp courtesy delay

This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay

SEE MORE:

 Climate Control Assembly

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. CAUTION: LH illustration shown, RH is similar. NOTE: The procedure must be carried out on both sides. Torque: 1.9 Nm Vehicles with manual transmission 2. Refer to: Gearshift Lever Knob (308-06 Manual T

 Wheel Knuckle

Special Tool(s) 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshafts to hang unsupported at one end or joint damage will occur. Make sure the halfshaft constant vel

© 2011-2025 Copyright www.rrevoque.org