Range Rover Evoque: Grass-gravel-snow

This program should be used

This program should be used where a firm surface is covered with loose or slippery material.

Note: For deep snow it is recommended that the Sand program is selected.

Note: If the vehicle is unable to gain traction in deep snow, switching DSC off may help. DSC should be switched on again, as soon as the difficulty is overcome.

READ NEXT:

 Mud-ruts

This program should be used for crossing terrain that is muddy, rutted, soft or uneven. HDC is automatically selected with this program.

 Sand

This program should be used for terrain which is predominantly soft dry sand or deep gravel. Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may h

 Wading

The maximum advisable wading depth is 500mm (19.7in). If the vehicle remains stationary in water above the door sill level, severe electrical damage may occur. Do not switch off the engine when

SEE MORE:

 Cooling Fan

Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Cooling System

 Drive Pinion Front Bearing

Special Tool(s) 100-012 Slide Hammer 205-067 Preload Gauge 308-615 Remover, Seals JLR-205-972 Mounting Bracket, Rear Axle JLR-205-984 Remover/Installer, Drive Pinion Nut JLR-205-985 Remover, Drive Pinion Bearing JLR-205-986 Installer, Drive Pinion Bearing Removal 1. Raise and support the vehicle. 2.

© 2011-2021 Copyright www.rrevoque.org