Range Rover Evoque: Powered tailgate opening height

The maximum opening height can be set as required. This is useful in parking areas with low ceiling heights or just for ease of use.

1. Open the tailgate to the position which you want to set as the maximum height. Press any tailgate control to stop movement at the required position. Final position can be achieved manually if required.

2. Ensure that the tailgate is stationary for at least three seconds.

3. Press and hold the tailgate close switch for ten seconds to set the maximum opening height.

4. Close the tailgate, then open again to check that it opens to the programmed height.

Note: If, after performing part 3 of the process the tailgate closes automatically, the required height has not been set. Repeat the process ensuring that all steps are adhered to.

To reset the maximum opening height, repeat the process, but when the tailgate reaches its current programmed height, manually move it to the fully open position before pressing and holding the button.

READ NEXT:

 Programmed position loss

The powered tailgate may lose its position memory if there are multiple object detections or if battery voltage is low. Powered operation may be inhibited. To reset the tailgate; 1. Manually close

 Changing the smart key batttery

When the battery needs renewing, there will be a significant decrease in the effective range and the message SMART KEY BATTERY LOW will be displayed in the message centre. To renew the battery:

 Exiting the vehicle

SEE MORE:

 PCS (Pre-Collision System)

The pre-collision system uses sensors to detect objects in the path of the vehicle. When the system determines that the possibility of a frontal collision with a detectable object is high, a warning operates to urge the driver to take evasive action and the potential brake pressure is increased to h

 Transmission Vehicles With: M66 6-Speed Manual Transmission FWD - Removal

Removal Special Tool(s) 205-857 Remover, Halfshaft 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine General Equipment Transmission jack 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refe

© 2011-2023 Copyright www.rrevoque.org