Range Rover Evoque: Electronic Engine Controls - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Electronic Engine Controls - GTDi 2.0L Petrol
- Electronic Engine Controls - Component Location
- Electronic Engine Controls - System Operation and Component Description
- Crankshaft Position (CKP) Sensor
- Catalyst Monitor Sensor
- Electronic Engine Controls
READ NEXT:
Electronic Engine Controls -
Component Location
Component Location
COMPONENT LOCATION - SHEET 1 OF 4
Fuel metering valve - HP Fuel pump
Camshaft Position (CMP) sensor (2 off)
Variable Camshaft Timing (VCT) solenoid (2 off)
Purge valve
Genera
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect
Network (LIN) Bus
CONTROL DIAGRAM - SHEET 1 OF 2
Battery
Starter motor fuse
Battery Junction Box (BJB)
Starte
SEE MORE:
Engine Emission Control - GTDi 2.0L Petrol
Emission Control -
Component Location
COMPONENT LOCATION
Intake manifold
Bolt (8 off)
Crankcase ventilation hose
Oil separator
Gasket
Camshaft cover
Lower clean air inlet duct
Upper clean air inlet duct
Camshaft cover vent hose
Air cleaner housing
Engine Emission Control -
Overview
OVER
Condenser GTDi 2.0L Petrol
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer t
© 2011-2025 Copyright www.rrevoque.org
