Range Rover Evoque: Electronic Engine Controls - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Electronic Engine Controls - GTDi 2.0L Petrol
- Electronic Engine Controls - Component Location
- Electronic Engine Controls - System Operation and Component Description
- Crankshaft Position (CKP) Sensor
- Catalyst Monitor Sensor
- Electronic Engine Controls
READ NEXT:
Electronic Engine Controls -
Component Location
Component Location
COMPONENT LOCATION - SHEET 1 OF 4
Fuel metering valve - HP Fuel pump
Camshaft Position (CMP) sensor (2 off)
Variable Camshaft Timing (VCT) solenoid (2 off)
Purge valve
Genera
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect
Network (LIN) Bus
CONTROL DIAGRAM - SHEET 1 OF 2
Battery
Starter motor fuse
Battery Junction Box (BJB)
Starte
SEE MORE:
Transmission Fluid Level Check
Check
WARNING: Observe due care when draining, as the fluid can be very hot.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Make sure that the automatic transmission is in the PARK position
and the handbrake is fully applied.
2. WARNING: Ma
Generator and Regulator - GTDi 2.0L Petrol
Generator - Component
Location
COMPONENT LOCATION
Battery positive connection
LIN (local interconnect network) bus connection
Generator
Generator - Overview
OVERVIEW
A single self-exciting generator is located at the front of the engine on the
LH (left-hand) side of the cylinder block. There
© 2011-2025 Copyright www.rrevoque.org
