Range Rover Evoque: Exterior lights

READ NEXT:

 Lighting control

Lighting control 1. With the headlamps on, push the control away from the steering wheel to select high beam. The instrument pack warning lamp will illuminate. Note: Do not use high beam where

 Daytime running lamps

Daytime running lamps are LED lamps. With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch

 Headlamp courtesy delay

This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay

SEE MORE:

 Crankshaft Position (CKP) Sensor

Special Tool(s) 303-1390A CKP Sensor Alignment Tool JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Wheel and Tire

 Single-point/multi-point entry

When you press the unlock button, your vehicle will unlock in one of two ways: 1. Single Point Entry: Unlocks the driver's door and fuel filler flap only. A second press is required to unlock the remaining doors and the tailgate. 2. Multi-Point Entry: Unlocks all doors, fuel filler flap and t

© 2011-2025 Copyright www.rrevoque.org