Range Rover Evoque: Brakes

READ NEXT:

 Foot brakes

Do not rest your foot on the brake pedal while the vehicle is in motion. Never allow the vehicle to coast (freewheel) with the engine turned off. The engine must be running to provide full bra

 Abs warning lamp

The ABS warning lamp illuminates briefly when the ignition is turned on. If this amber warning lamp illuminates when driving (accompanied by an associated warning message), drive with extra caut

 Steep slopes

If the vehicle is stationary on a steep, slippery slope, it may begin to slide even with the brakes applied. This is because without wheel rotation, the ABS cannot determine vehicle movement. To

SEE MORE:

 Rear Lamp Mounting Panel

Removal NOTES: The rear lamp mounting panel is manufactured from mild steel. The section of the rear lamp mounting panel described within this procedure is for the access for installation of the inner back panel assembly. The upper NVH component must be replaced when a complete panel is installed

 Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension

Special Tool(s) JLR-204-804 Lever, Wheel Knuckle General Equipment Transmission jack Wooden Block CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. LH illustration shown, RH is similar. NOTES: Removal steps in this procedure may contain installation d

© 2011-2025 Copyright www.rrevoque.org