Range Rover Evoque: Brakes
READ NEXT:
Do not rest your foot on the
brake
pedal while the vehicle is in motion.
Never allow the vehicle to coast
(freewheel) with the engine turned off.
The engine must be running to provide
full bra
The ABS warning lamp illuminates
briefly when the ignition is turned
on.
If this amber warning lamp illuminates when
driving (accompanied by an associated
warning message), drive with extra caut
If the vehicle is stationary on a steep, slippery
slope, it may begin to slide even with the
brakes applied. This is because without wheel
rotation, the ABS cannot determine vehicle
movement.
To
SEE MORE:
Removal
NOTES:
The rear lamp mounting panel is manufactured from mild steel.
The section of the rear lamp mounting panel described within this procedure is
for the access for installation of the
inner back panel assembly.
The upper NVH component must be replaced when a complete panel is installed
Tyre information label location.
Tyre pressures should be
checked
regularly using an accurate pressure
gauge, when the tyres are cold.
The following procedure should be used to
check and adjust the tyres pressures.
1. Remove the valve cap.
2. Firmly attach a tyre pressure gauge/inflator
© 2011-2021 Copyright www.rrevoque.org